II.1)
Scope of the procurement
IA12 Sub Systems: Port plug, DSM an DFW
Reference number:
T/BO062/22
42000000
-
Industrial machinery
Supplies
II.1.4)
Short description
UK Atomic Energy Authority (UKAEA), based at the Culham Science Centre in Oxfordshire, hereafter referred to as the Purchaser, carries out research into the use of controlled fusion for the generation of power.
In support of the international ITER fusion experiment, under the ITER Robotic Test Facility (IRTF) scope of work, the Purchaser aims to demonstrate the feasibility of remote maintenance operations, that will be carried out within the ITER Hot Cell Complex (HCC).
This is being demonstrated through full-scale physical mock-up trials, at the premises of the Purchaser. The results of these trials will inform the final design of the relevant components and systems.
As part of this work, the manufacture and assembly of a mock-up Port Plug, Diagnostic Shield Module (DSM) and Diagnostic First Wall (DFW) and all associated fixings is required.
II.1.5)
Estimated total value
Value excluding VAT: 280000.00
GBP
II.1.6)
Information about lots
This contract is divided into lots:
no
II.2.2)
Additional CPV code(s)
42100000
-
Machinery for the production and use of mechanical power
42900000
-
Miscellaneous general and special-purpose machinery
51100000
-
Installation services of electrical and mechanical equipment
51120000
-
Installation services of mechanical equipment
71333000
-
Mechanical engineering services
71334000
-
Mechanical and electrical engineering services
II.2.3)
Place of performance
NUTS code:
UKJ14 -
Oxfordshire
II.2.4)
Description of the procurement
UK Atomic Energy Authority (UKAEA), based at the Culham Science Centre in Oxfordshire, hereafter referred to as the Purchaser, carries out research into the use of controlled fusion for the generation of power.
In support of the international ITER fusion experiment, under the ITER Robotic Test Facility (IRTF) scope of work, the Purchaser aims to demonstrate the feasibility of remote maintenance operations, that will be carried out within the ITER Hot Cell Complex (HCC).
This is being demonstrated through full-scale physical mock-up trials, at the premises of the Purchaser. The results of these trials will inform the final design of the relevant components and systems.
As part of this work, the manufacture and assembly of a mock-up Port Plug, Diagnostic Shield Module (DSM) and Diagnostic First Wall (DFW) and all associated fixings is required.
It should be noted that although it will be necessary to manufacture the components to the exacting standards required for the Purchaser site, they will not be operating in a radiation environment.
II.3)
Estimated date of publication of contract notice:
06/04/2022